OpenHW CVE2 / CV32E20 on ALINX PI-AR035-F1-1 ==================================================== Status: verified on hardware (2026-11-20) Board: ALINX PI-AR035-F1-1 (AR035 series) FPGA: AMD XC7A35T-FGG484-2 Vivado part: xc7a35t-2fgg484 Toolchain: Vivado 2023.2, riscv-nuclei-elf-gcc 10.2 (rv32imc/ilp32) Upstream: https://github.com/openhwgroup/cve2 Upstream commit: d7f21568028a1114be663599bd42145dccf28928 License: Apache-2.0 (see LICENSE) What is verified ---------------- - CVE2 RISC-V core integrated into a minimal SoC with 16 KiB instruction RAM and 16 KiB data RAM. - 50 MHz clock, UART TX at 0x1000_0000, 115200 8N1, LED1 heartbeat. - Synthesis, implementation and bitstream generation complete. - Bitstream downloaded over JTAG; serial output observed on /dev/ttyUSB0: hello cve2 hello cve2 hello cve2 Pin map ------- clk Y18 onboard 50 MHz oscillator rst_n M6 RESET/KEY3, active low, external 10K pull-up led M5 LED1, active low uart_tx L5 FPGA TX -> CH340 RXD Build ----- 1. Copy this package to a Linux machine with Vivado 2023.2. 2. Build firmware: cd sw make clean && make 3. Build FPGA: source /path/to/Vivado/2023.2/settings64.sh vivado -mode batch -source tcl/build.tcl -log build.log -journal build.jou 4. Program: vivado -mode batch -source tcl/program_2023.tcl -log program.log -journal program.jou 5. Open UART: stty -F /dev/ttyUSB0 115200 cs8 -cstopb -parenb raw -echo timeout 3 cat /dev/ttyUSB0 Files ----- rtl/top_cve2.sv minimal SoC: CVE2 + RAM + UART + LED xdc/pi_ar035_f1_1_cve2.xdc pin constraints tcl/build.tcl Vivado project build tcl/program_2023.tcl JTAG programming sw/start.S, main.c, link.ld firmware source sw/Makefile firmware build sw/bin2hex.py.txt hex generator (rename to .py before use) sw/firmware.hex prebuilt firmware image bit/top_cve2.bit verified bitstream reports/timing.rpt, util.rpt timing and utilization reports Not verified in this round -------------------------- DDR3, timer, interrupt controller, UART RX, CoreMark, PLL 100 MHz.